Innovate-motorsports LM-1 RPM Converter (Aux. Input Cable 2) Instrukcja Użytkownika Pobierz pdf (Strona 1)

LM-1 RPM Converter (Aux. Input Cable #2)

USER MANUAL

1 2 3 4 5 6 7 8 9

LM-1 RPM Converter (Aux. Input Cable #2) USER MANUAL

LM-1 Aux Input Cable and RPM Converter 1. Introduction The LM-1 Aux Input Cable #2 (RPM-converter) is an auxiliary device for the LM-1 Lambda Met

The RPM pulse input is used when using an RPM-pulsed signal other than the inductive clamp. See chapter 2 for specifics about the RPM pulse input. Th

2.2 Two-Stroke Engines On a 2-stroke engine there is a spark for every crank rotation, so the spark frequency doubles compared to a 4-stroke.Very few

3.1 Inductive Clamp Usage - Plug the inductive clamp's 3.5mm audio plug into the inductive clamp input of the RPM converter. - Clamp the Inducti

5. Setup of the RPM-Converter for different rpm pulses/rotation During the setup procedure the RPM converter measures the number of pulses for 5 seco

Figure 3. RPM-Converter Setup Page Select the engine type and number of pulses per crank rotation. Then press the setup button. Follow the instruct

6. RPM Converter Specification Min Typical Max Unit Measurable RPM (Note1) 100 10,230 RPM Input frequency 0.8 1100 Hz Input Pulse Amplitude

7.1 Recording the state of a NOS solenoid or Figure 4. Solenoid Interface (High Side Switch, Low Side Switch) In the left case the solenoid is

Brak uwag

Innovate-motorsports LM-1 RPM Converter (Aux. Input Cable 2) Instrukcja Użytkownika Strona 1